Wax Bowl Luminaries

apm2012
2
Comments

This DIY was found on the Wedding Belles from the bridal lounge. It is a step-by-step instruction on how to make wax bowl tealight holders.


 


Lovely Lumieres… Monday DIY!!!



Monday DIY is back!!! Hope you’re all sufficiently rested after lovely weekends to feel up to tackling this gorgeous little project that we found on www.candletech.com. So simple to make, and so gorgeous for any party or wedding, these little wax lumieres can be made in any size (depending on how big you make the balloons), so we’d suggest making lots and lots of all different dimensions and group them together to create glowing, organic centerpieces. Also, if you’re feeling braver, mix some colour into the wax and play around with different shades and tones – we’re going to try milky pinks and peaches for a soft, romantic feel… we’ll keep you posted on how we get on!! Enjoy, Aoife & Deirdre xx


Now for the ‘How-To’… we’re giving you the pretty pictures first, and the instructions below ;0)


You will need : High Melt Paraffin Wax (try most good craft stores),  party balloons, a double boiler, non-stick cookie / biscuit sheet.



1. Fill balloon with tepid water.


2. Melt your wax. Optimum working temperature for this project is 180 degrees Fahrenheit. Try to maintain this temperature for your wax while working by keeping it on a double boiler.


3. Slowly dip your balloon into the wax  to just below the water level in the balloon. Warning: Do not dip the balloon into the wax past the water level. This could cause the balloon to pop.


4. Hold the balloon in the wax for a few seconds, and then slowly lift it out of the wax. Dip the balloon a few more times, allowing some time between dips to let the wax cool.


5. While it is still quite warm, carefully set the balloon down onto a piece of paper or a cookie sheet, making sure it is level. This will create a flat bottom for the lumiere.


6. Dip your balloon a few more times until it is the desired thickness. A good target thickness is 1/4 to 1/2 of an inch.


7. Set the balloon on the paper or cookie sheet again and let it cool.


8. When the wax is completely cooled, hold the balloon over a sink or bucket, facing away from you. Carefully pop the balloon with a skewer or knife and let the water drain out. Throw away the balloon shards.


9. To level the top of the lumiere, heat a cookie sheet on the stove and place the lumiere top-down onto the hot sheet and carefully melt the edges until it is level.


10. Place a tea light or votive inside the lumiere and burn on a candle holder in a dark area…. gorgeous!


1
Last Updated: December 29, 2013 at 9:10 pm
Tags: DIY Wedding
2
Comments
Log in or Sign up to post a comment
1375011372 small thumb 4dfd55fdb0afd6ad3560cf93604f2cd3
1375011333 small thumb f16199d9271a5cbb686d0771ba6c0e41
Other ideas in My Project Wedding Board by apm2012
1375585784 thumb efba8b39eabc6b3a748dc90de944f5d1 m No image idea 1375590403 thumb 4ec9efc65b83ac4fa19b6814530b3a3c s 1375592820 thumb c344a2e27ffbeabf61a3a5055cc9ced0 m 1375594872 thumb e57b04d8a34307d210b3b75319d8d24b m 1375589925 thumb 129b33aad9cbbab1ce8a552f4da5257d m

Find Your Wedding Vendors

Featured Vendors Near You

Chat About It